Cone meter

Engineered primary element for DP flow measurement in applications with limited installation space

  • Meter run with integrated cone and single taps according to EN ISO 5167-4
  • Rugged solution for difficult media and harsh operating conditions, e.g. in oil and gas applications
  • Designed for large diameters (up to 24″), demanding flow profiles, high pressures and temperatures

Cone meter

Engineered primary element for DP flow measurement in applications with limited installation space

  • Meter run with integrated cone and single taps according to EN ISO 5167-4
  • Rugged solution for difficult media and harsh operating conditions, e.g. in oil and gas applications
  • Designed for large diameters (up to 24″), demanding flow profiles, high pressures and temperatures

Overview

A cone meter is an engineered primary element for demanding DP flow applications with reduced inlet/outlet runs where other primary elements cannot be used. It comes pre-assembled with a cone installed in a closed pipeline that is welded in a meter run. It is completely flexible as to the selection of the wetted materials and can be manufactured from any material in accordance with the ISO 5167 standard. The typical 12" or 34" taps have a butt or socket weld, thread or flange connection. The taps can be equipped with condensate chambers and shut-off valves.

Product features and options depend on device configuration: Contact us to make sure that your preferred functionality can be combined in one device.

  • Compact or separate design
  • Also available as engineered version for advanced requirements, e.g. extreme temperatures (-270…+1400°C / -454…+2552°F)
  • Can be made from any material if in accordance with ISO standard
  • Low maintenance and long life with low total cost of ownership (TCO)
  • Possible for tight-fit and retrofit installations
  • Shortest possible upstream and downstream straight length for installation
  • Available with calibration in accordance with national and international standards
  • Low uncertainty: ±0.25….0.35% (calibrated)
  • Taps can be equipped with condensate chambers and shut-off valves

Related products

Cone flowmeter

DP flowmeter for limited installation space

  • Only limited straight inlet/outlet pipe sections required
  • Standard material: stainless steel, other materials on request (e.g. Alloy C276, Alloy 625, Alloy 400, Duplex, etc.)
  • Standard (ISO 5167-5) sizes from DN50…600 / 2…20"
  • 2-wire 4…20 mA/HART®, FF, Profibus-PA

OPTIBAR DP 3050

Differential pressure transmitter for general flow, level and differential pressure applications

  • The most compact design in its class
  • Measuring ranges: 100 mbar…16 bar / 1.45…232 psi; Line pressure: up to 160 bar / 2320 psi
  • Reference accuracy ± 0.1%
  • 2-wire, 4…20 mA/HART®7

OPTIBAR DP 7060

Differential pressure transmitter for flow, level, differential pressure, density and interface measurements

  • High performance DP transmitter with integrated line pressure measurement
  • Measuring range: 30 mbar…16bar / 0.44…232 psi; Line pressure: up to 700 bar / 10,153 psi
  • Reference accuracy of ±0.065%
  • 2-wire, 4…20 mA/HART®, FF, Profibus-PA, Bluetooth®
Email
Contact